gate
glass
circular saw
2"x4" lumber
sandpaper
stain
1. Cut the door to the desired size using a circular saw. The mirrored section measures 5' x 8" with an additional five inches on one side and 11 inches on the other.
2. The door will extend two inches past the mirror on each side.
Tip:To make sure the mirror doesn't extend into the cutout area, drill a hole an inch from the edge, then two inches, and so on.
3. Clean the door and then sand any scratches and rough edges.
4. Cut one 2 x 4 to 54 inches, then tear to width of door-1 3/4 inches.
5. Cut two 2 x 4's to 25 inches.
6. Build the base of the shelf. Attach the 25-inch 2 x 4 pieces to the 54-inch pieces on each side and center.
7. Stain all the pieces.
8. Screw the base of the shelf to the door.
1. Find and mark the studs on the wall.
2. Determine the placement of the bed.
3. Place the door on the wall studs.
4. Touch up as needed.
Now Playing 
Now Playing 
Now Playing 
Now Playing 
Now Playing 
Now Playing 
Now Playing Now Playing 
Now Playing 
Now Playing 